Many of you read how our trucks can be broken into just by using a screw driver to by pass the handle backplates.
I wasted no time and bought some for the truck. I just got around today to putting them in.
Hope this helps.
8mm,10mm socket,extension,phillips sd,flat head.
Refer to Venoms speaker thread for pics and how to remove door panals so as not to tear them up guessing.
The passenger side took 15 minutes after I did the driver side.
pic 5: Using a flat head remove lock bar by opening the V clip a little. Instruction say to have key in.Dont need to.
After that you remove the 10MM bolts that are in the door handle bracket.
Pic 6 : place bracket on but ,you must angle and tweak the lock rod receiver a little and then the plate/jammer slides on the bolts.
Pic 7:Pull the rear of the plate as high as the bolt slot allows and tighten both sides.I saw that the rod might catch the plate so here I bent it in a little to help.
On the passenger side door I used a cresent wrench before I started.
Test the key and electronic locks, put everything back together.
the site has online distributors. I got mine from like truck security's website. They're all priced around the same. Finally bought and installed mine about 2 weeks ago.