you can do it all save the money on labor...then take it over for an alignment....
or have them do it
you can do it all save the money on labor...then take it over for an alignment....
or have them do it
Stew is right (as always)
It's a pain, but not really that hard to do your self!!
I did it all and I'm OLD!
LFP cold air, idlers & SBTB, Steig ported Eaton & intake, BA2600, C&L, Punisher, Belltech suspension Rotor Pros, Harwood hood JVC audio & other stuff I can't remember over the last 2.5 years! Tuned by JJ@WMS
Found the cam bolts for 60 on LPF and clunk washers for 35. Guess ill get those ordered. Just ordered new front tires. Need to get this front end squared away
2002 Harley Davidson F150
Intake-C&L elbow-SBTB-L upper/snout-4# Lower-Bassani catted mid-Bassani Cat Back-VB-Diablo tuned-Best time: 13.8 @ 100.7
Soon to be: 6# lower-SCT MAF-Custom Tune
Against previous suggestions I ordered GT IIs. The rears are brand spanking new and I just didn't want mismatched tires. I only do about 4K miles a year so they should last quite a while
Nice choice Merlin!
I just did the same - 275 front & 295 rear.
Handle great, low noise - we will have to see what they do in rain & yukky stuff however.
Much better than the Kumos previously on there.
http://www.rockauto.com/catalog/more...614&cc=1422728
This is it correct? I need two pairs? They're 15.59 a set on Rock Auto, seems like a good deal, no?
Oh dang, I thought I only needed 4. I still need to figure out where all of them go, all I know is I was told I needed them lol
4 total two per side....they go in the upper control arm
So the pic of 8 is wrong? lol
I'm cornfused
there's only 4 in the pic in this thread...
2002 DSG HD #09617 NHTOC Truck of the month November 2012
Ported eaton/plenum/tb, 6lb lower, SCT BA-2600 MAF, OBX longtubes, JLP intake, FTVB, L-spec bilsteins, Hotchkis TVS, 22" replicas. Tuned by Ray McClelland of FTK