Hello. I recently purchased an svo single blade throttle body. My question is will my stock maf sensor work with this throttle body? I have stock pullies right now. Also cai. Thanks for your input!!
Hello. I recently purchased an svo single blade throttle body. My question is will my stock maf sensor work with this throttle body? I have stock pullies right now. Also cai. Thanks for your input!!
should work fine. I'd be more concerned if the size changed about fitting your stock air inlet tubing over the throttle body.
2002 DSG HD #09617 NHTOC Truck of the month November 2012
Ported eaton/plenum/tb, 6lb lower, SCT BA-2600 MAF, OBX longtubes, JLP intake, FTVB, L-spec bilsteins, Hotchkis TVS, 22" replicas. Tuned by Ray McClelland of FTK
x2 a throttle body swap does not affect the tune
the following was jacked from: http://efidynotuning.com/post.htm
Retuning Required
Retuning is required under any of the following circumstances
MAF sensor changes - all changes must be made in the MAF transfer ONLY, this includes and inlet piping changes
Fuel Injector changes - all changes must be made in the injector parameters ONLY
Fuel Pressure changes - all changes must be made in the injector parameters ONLY
Cylinder Head Replacement - spark table and peak load function must be updated
Camshaft Replacement - idle air control MAY need to be updated and spark advance possibly
Base Timing changes - Ignition timing (spark table) and injector timing must be updated (doesn't apply to edis)
Fuel Grade changes, ex: E-85 or 87 Octane - AFR parameter and/or spark table must be updated