S/C-HD2002,
I'm new here, but have the L Sway bar already and need further clarification on one of the steps.
In one of your steps above, you said the following:

"Brake line relocation bracket. Basically fabbed out of a flat piece of 1/8 inch bar stock. I drilled two offset holes (one for the vent and one for the brake line T) and bolted everything back in place. I used a shock bushing insert (cut in half) to take the place of the T block on the vent tube."

2 questions:
1) You didn't happen to snap a pic of the bracket before installing it did you?
2) What do you mean by using a "stock bushing insert (cut in half)....."?

Feel free to e-mail me if you wish. Thank You.