Quote Originally Posted by Dbl G View Post
Small word of caution folk's I have worked on one of these that there were some issues with two of the bearing posts on it & has caused rapid replacement of bearings too the tune of 1 about every 1K.

Charles said and is replacing as one would expect,, just check them over well so he can return them before there worn. At least he won't have to chance eating them on a replacement with his manufacture.....
Not to create an issue, Garrett. I have done business with MP for years. They are located just down I-5 on the east-side of the Portland area. They do great work with Precision Castparts Inc, etc. The last group-buy (over 20 units on "short-order") had only 2-3 that were machined with more than .5 of 1/1000th out of "tol". Emory cloth can take care of that on the pulley-boss. They make really nice/high-quality products.